Injection mould design basics

By the CAD CAM Galaxy team · Updated 16 Nov 2026

An injection mould is a two-part steel tool. Molten plastic is injected into the space between the cavity and the core, cools and solidifies, and the mould opens so ejector pins can push the part out. Good mould design is mostly about how the plastic flows in, how it cools and how the part comes out.

The main parts of a mould

  • Cavity and core: the two halves that form the outside and inside of the part.
  • Parting line: where the two halves meet. It decides where witness lines show and whether the part can be released.
  • Gate and runner: the channel that carries plastic from the machine nozzle into the cavity. Gate type and position affect fill, appearance and strength.
  • Ejector system: pins or plates that push the part out after cooling.
  • Cooling channels: water passages that remove heat. Cooling usually decides the cycle time.

Part design rules that save money

  • Add draft angles to walls so the part releases without scraping.
  • Keep wall thickness as even as possible to reduce sink marks and warping.
  • Use ribs for stiffness instead of thick sections.
  • Avoid undercuts where you can, since they need slides or lifters that add cost.

Why simulation helps

Mould-flow simulation predicts filling, packing, cooling and warpage before steel is cut. It helps decide gate location, check for weld lines and air traps, and adjust cooling. It does not replace experience, but it catches expensive mistakes early.

Need help or a quotation?

CAD CAM Galaxy supplies licensed CAD/CAM software and trains engineers across India, with centres in Mumbai, Palghar and Vapi. Use the form below or see the related pages.

Get a quote for your licences

Tell us which software you need, how many seats, and what your team machines or designs. We quote, supply, install and support — and reply within one working day.

Hours

Mon – Sat: 10:00 AM – 7:00 PM

WhatsApp Call us